MC275

Vacuum Tube Amplifier

This tube power amplifier has all the features to meet the needs of today’s music enthusiast, while preserving the qualities that have made the MC275 the most revered McIntosh tube amplifier.

This sixth generation MC275 has many subtle enhancements from the previous release that greatly improve performance. Combined with the widest bandwidth McIntosh output transformer design, the MC275 features tauter bass control and thermally quiet circuit design. The result is pure music.

McIntosh patented, gold plated, speaker binding posts assure the best connection to all speaker cables, while high quality balanced and unbalanced input connectors enhance signal transfer from the connected preamplifier.

The seven small tubes are LED illuminated to indicate the amplifier’s functional status. Power Control is used to remotely control tube illumination from a McIntosh preamplifier.

Circuit Design: The All Tube Circuit Design allows only the tubes to amplify the input signal, for the best tune amp listening experience.

Sentry Monitor: The High-Speed Sentry Monitor protection circuitry shuts down the amplifier in case of a rare tube malfunction before additional damage can occur. The small tubes closest to the defective output tube set will illuminate Red to indicate which pair of output tubes need replacing. If speaker wires are inadvertently shorted, Sentry Monitor will shut the amp off and the power LED on the input side of the amp will flash. Once the speaker wires are corrected, the amplifier will power back up.

Tube Illumination: The seven small tubes sequentially warm up with an intense amber hue until the amplifier reaches operational stability, causing the tubes’ illumination to change to green. When the small tubes are green, voltages are stabilized and the amplifier is ready to enjoy.

Monophonic Operation: MC275 is designed to use as a single chassis 150 watt mono power amplifier. A Gold Platted mono speaker jumper is included to connect the two channels together for monophonic use when high power is needed for larger speakers or higher playback volumes.

• Power Output: 75 Watts Minimum sine wave continuous average power output per channel, stereo, with both channels operating
• Mono Parallel: 150 Watts @ 2, 4 and 8 ohms
• Output Load Impedance: Terminals for 4, 8 and 16 Ohms Stereo
• Rated Power Bandwidth: 20 Hz to 20 KHz
• Total Harmonic Distortion: 0.5% maximum harmonic distortion at any level from 250 milliwatts to rated power